For the engraving machine, it is easy to rust when not in use. Due to the wet workshop environment, some parts of the engraving machine are easily rusted, such as: metal parts such as bed, main shaft, guide rail, etc., then the engraving machine is used again. The engraving performance will be affected, which may reduce the production schedule and accuracy. In order to make the idle engraving machine get better maintenance, the engraving machine manufacturer introduces the specific maintenance method for everyone.
1. Surfaces of steel parts, such as ball screws, hardened steel raceways of rolling guides, and steel fastener surfaces, should be rubbed with cloth or cotton 蘸 butter every few days. Other parts should be observed frequently. Weak rust, if used, wipe with oil, and as the focus of future rust.
2, the surface of aluminum parts, should also be rubbed with cloth butter every few days, can also spray a layer of varnish. And often observe whether there is corrosion point.
3, the cooling water tank is best to emulsified oil to facilitate rust, do not use water.
For the engraving machine, pay attention to moisture and moisture. After use, keep the machine itself clean and often replace the lubrication, so as to ensure the normal operation of the engraving machine is not wrong!
